A Rancho Cucamonga sump pump that stops working usually has a tripped circuit, a stuck float, a bad check valve or a worn motor. Pumps are uncommon in slab-built homes here, so they mostly serve lower-level rooms, low spots on a lot and commercial pits. Call the number on this page to be connected with a local plumber in Rancho Cucamonga.
Pumps in Rancho Cucamonga
Rancho Cucamonga stretches from Foothill Boulevard, the old Route 66, up toward the foothill neighborhoods of Alta Loma and Etiwanda. Most houses here have no basement, so a pump typically means a specific setup: a below-grade room, a lot where runoff collects during winter storms, or a business with an equipment pit. Cucamonga Valley Water District supplies the city's water. Power comes from either Southern California Edison or the city-owned Rancho Cucamonga Municipal Utility, depending on where you are, and that is the company to call if the outage is on their side.
What to do right now
- If water is near the outlet or pump cord, turn off that circuit at the breaker panel before going near the pit.
- Check whether other outlets in the house have power. If not, call your electric provider.
- If the power is on, look for a tripped GFCI outlet and reset it once. If it trips again, leave it off.
- Lift the float gently with a dry stick. If the motor starts, the float was stuck.
- Go outside and confirm the discharge pipe is not crushed or blocked.
- Move belongings off the floor and call a plumber if the pit keeps rising.
Skip extension cords strung across a wet floor, and do not reach into the pit while the pump is plugged in. If the pit serves a lower-level bathroom, stop using those fixtures until the ejector is working again, since anything you flush has nowhere to go.
Symptoms and likely causes
| Symptom | Likely cause |
|---|---|
| Pump silent, pit full | No power, tripped GFCI, stuck float or burned-out motor |
| Hums but moves no water | Jammed impeller or blocked discharge line |
| Starts and stops every few seconds | Failed check valve or float set too tight |
| Runs nonstop | Float stuck up, or more water entering than the pump can handle |
| Sewage smell | Dry trap, or an ejector basin with a bad seal or vent |
What affects the cost
- Repairing a switch or valve versus replacing the pump
- Sump pump or sewage ejector
- Rerouting or extending the discharge line
- Basin replacement or a new sealed lid
- Adding a battery backup or alarm
- A permit through the City of Rancho Cucamonga Building & Safety Online Permit Center, if plumbing is changed
Sump Pumps questions in Rancho Cucamonga
What happens to the pump when the power goes out?
What is the difference between a sump pump and a sewage ejector pump?
What should I do if the pit is overflowing during a storm?
How can I test a sump pump myself?
More plumbing services in Rancho Cucamonga
Sump Pumps nearby
Helpful guides
Sources
Last updated: